Standalone Mediaport; Application Setup; Overview; Video Input And Output - Extron electronics MediaPort 200 User Manual

Standalone
MediaPort 200

Application Setup

The MediaPort 200 can integrate seamlessly into a variety of applications. This section
contains instructions on how to set up the MediaPort 200 for the following application:
•
This application is one of many configurations for the Standalone MediaPort and was
designed to give a fundamental understanding of the MediaPort 200 in a common
application.

Overview

This section contains a general discussion of MediaPort 200 inputs and outputs and
their intended uses when the MediaPort is 200 is used as a standalone device. All of the
principles described here are used in the application setup procedure that follows.
NOTE: Ensure the MediaPort 200 is set to Standalone audio mode in PCS before

Video Input and Output

HDMI Input

The HDMI Input can be fed from a camera, a computer, HDMI switcher, or other HDMI
source. The HDMI source can be a video conference or document camera without audio.
The source can also be a PC or switcher output that includes embedded audio. If the HDMI
input includes microphone audio, the HDMI audio should be muted.

HDCP-Compliant HDMI Loop-Out

The HDCP-Compliant Loop-Out can be used as a local monitor output or can be fed into
a hardware video codec. If required, adjust the HDCP output settings via PCS (see
Loop
SIS Commands (see
Device
Application 1

— Standalone MediaPort 200

beginning setup (see General Settings Tab
selecting Standalone audio mode).
on page 42), the front panel (see
HDCP Authorized — Input Reporting as an HDCP Authorized
on page 123).
on page 59 for more information about
Output Configuration Menu
MediaPort 200 • Standalone Application Setup
HDMI
on page 73) or
83