Milling Support; Turning Support - Siemens SINUMERIK 840D Programming Manual

12.97
08.99
1

Milling support

The milling support includes the following selection possibilities:
Face
milling
Path
milling
Standard
pockets
Slots
Thread
milling
Spigots
The "Standard pockets" and
"Slots" softkeys each branch
into submenus offering a
selection of pocket and
groove milling cycles.

Turning support

The turning support includes the following selection possibilities:
Cutting
Thread
Groove
Undercut
The undercut cycles for the
E and F forms (CYCLE94)
as well as for the thread
undercuts of
the A to D forms (CYCLE96)
are all stored under the
"Undercut" softkey.
The "Thread" softkey contains a submenu for
selecting between single thread cutting or thread
chaining.
 Siemens AG 2000 All rights reserved.
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide, Cycles (PGZ) - 04.00 Edition
1.5 Cycle support in the program editor (SW 5.1 and later)
General
1
1-45