Siemens SINUMERIK 840D Programming Manual page 91

03.96
2
Further notes
Explanation of this example
The modal call must be deselected in block N80
because in the next block the tool is traversed to a
position where no drilling is to be performed.
It is advisable to store the drilling positions for a
machining task of this type in a subroutine which is
then called at MA1 or MA2.
In the description of the drilling pattern cycles on the
following pages in Section 2.3, the program using
these cycles has been adapted and thus simplified.
The drilling pattern cycles are based on the call
principle
MCALL DRILLING CYCLE (...)
DRILLING PATTERN (...).
 Siemens AG 2000 All rights reserved.
SINUMERIK 840D/840Di/810D/FM-NC Programming Guide, Cycles (PGZ) - 04.00 Edition
Drilling Cycles and Drilling Patterns
2.2 Modal call of drilling cycles
2
2-91