Basic Functions; Plug And Play - Philips FWM399 User Manual

Basic Functions

IMPORTANT!
Before you operate the system, complete
the preparation procedures.

Plug and Play

Plug and Play allows you to store all available
RDS stations and radio stations automatically.
First time setup/power up
1
When you turn on the main supply, "AUTO
INSTALL - PRESS PLAY" is displayed.
2
PressÉ Å on the system to start installation.
➜ "INSTALL" is displayed, followed by "TUNER"
and "AUTO".
➜
starts flashing.
PROG
➜ The system will automatically store the radio
stations with sufficient signal strength, starting
from all RDS stations and followed by FM, MW
and LW bands respectively. Weak RDS stations
may be stored in later presets.
➜ When all the available radio stations are
stored or the memory for 40 presets are used,
the last preset radio station (or the first available
RDS station) will be played.
3
The system will proceed to set the RDS clock if
the first preset is an RDS station.
➜ "INSTALL" is displayed, followed by "TIME"
and "SEARCH RDS TIME".
➜ When RDS time is read, "RDS TIME" is
displayed and the current time will be stored.
12
(for tuner installation)
➜ If RDS station does not transmit RDS time
within 90 seconds, the programme will exit
automatically and the display will show "NO RDS
TIME".
G If the first preset is non-RDS station;
➜ The programme will exit automatically.
To reinstall Plug and Play
1
In standby or demonstration mode, press and
holdÉ Å on the system until "AUTO INSTALL
- PRESS PLAY" is displayed.
2
PressÉ Å again to start installation.
➜ All previously stored radio stations will be
replaced.
To exit without storing the Plug and Play
G Press Çon the system.
➜ If you do not complete the Plug and Play
installation, the function will be restarted when
you next turn on the main supply again.
Notes:
– When the power is turned on, the disc tray may
open and close to initialise the system.
– If no stereo frequency is detected during Plug
and Play, "CHECK ANTENNA" will be displayed.
– During Plug and Play, if no button is pressed
within 15 seconds, the system will exit Plug and
Play mode.