Chevrolet T-Series Owner's Manual page 92

Setting Cruise Control
J
SET: Press this button at the end of the
multifunction lever to set the cruise control speed.
+ RES: Move the band to this position to
resume the set speed.
CAUTION:
{
If you leave your cruise control on when
you are not using cruise, you might hit a
button and go into cruise when you do not
want to. You could be startled and even
lose control. Keep the cruise control switch
off until you want to use cruise control.
J
1. Press the button to turn the cruise control
on. The light inside the switch will turn on.
92
This button is located
at the lower left side of
the instrument panel.
It turns the cruise
control on and off.
2. Get up to the speed you want.
J
3. Press in the SET button at the end of the
lever and release it.
4. Take your foot off the accelerator pedal.
Resuming a Set Speed
Suppose you set the cruise control at a desired
speed and then you apply the brake or the clutch.
This, of course, shuts off the cruise control. But
you do not need to reset it.
Using the accelerator pedal, increase your
vehicle's speed to 25 mph (40 km/h) or more. The
cruise control does not work below this speed.
Turn the band on the lever to the +RES position
and release it. The vehicle will accelerate to
the previously set speed.