Emergency Calls - Kenwood Nexedge NX-220 Instruction Manual

code, the transceiver becomes disabled. The stun code is
cancelled when the transceiver receives a call with a revive
code.

EMErGENCy CAllS

If your transceiver has been programmed with the Emergency
function, you can make emergency calls.
1 Press and hold the key programmed as [Emergency].
• Ask your dealer for the length of time necessary to hold this
key before the transceiver enters Emergency mode.
• When the transceiver enters Emergency mode, it will change
to the Emergency channel and begin transmitting based on
how it is set up by your dealer.
2 To exit Emergency mode, press the [Emergency] key
again.
• If the Emergency mode completes a preset number of cycles,
Emergency mode will automatically end and the transceiver
will return to the zone and channel that was in use before
Emergency mode was entered.
Note:
◆ Your dealer can set the transceiver to emit a tone when
transmitting in Emergency mode.
◆ Your dealer can set the transceiver to emit tones and received
signals as normal, or mute the speaker during Emergency
operation.
■ Activity Detection
Press the key programmed as [Activity Detection],
toggle Activity Detection ON and OFF. If an event occurs
while Activity Detection is enabled, the transceiver enters
Emergency mode.
Note:
◆ When Activity Detection has been turned off, and the
transceiver power is then turned off and back on, Activity
Detection is automatically enabled.
◆ When using this function, verify that it operates before
taking the transceiver.