Preparations; Step 1: Inserting Batteries Into The Remote Control; Step 2: Setting The Clock - Philips FWD796/21 User Manual

IMPORTANT!
– Make sure to complete the
preparation procedures before operating
the system.
Step 1: Inserting batteries into
the remote control
3
1
2
1
Open the battery compartment.
2
Place two batteries (Type R06 or AA) in the
compartment with the correct polarity as
indicated by "+" and "–" symbols.
3
Close the cover.
Using the remote control to operate the
system
1
Point the remote control directly
at the remote sensor (iR) on the
front panel.
2
Select the source you wish to
control by pressing one of the
source select buttons on the
remote control (for example
TAPE1/2, TUNER).
3
Then select the desired function (for example
2;, O or P).
CAUTION!
– Remove batteries if they are
exhausted or will not be used for a long
time.
– Do not use old and new or different
types of batteries in combination.
– Batteries contain chemical substances,
so they should be disposed of properly.

Step 2: Setting the clock

The clock can be set in either 12-hour or 24-
hour mode ("PM 00:00" or "00:00" for
example).
1
The clock can be set in any source mode.
If you have not set the clock, "--:--" will be
shown on the display.
2
Press and hold CLOCK and "00:00" blinks on
the display.
The current time is flashing on the display.
If you have not set the clock, "--:--" will appear
on the display.
3
Press O or P on the system to set the
hours.
4
Press 1 or ¡ on the system to set the
minutes.
5
Press CLOCK to confirm your setting. Clock
will be shown on the display for 5 seconds and
then go back to it's previous status. The system
will store the setting automatically.
The time setting becomes effective.
To exit the setting without storing (in
standby mode)
Press 9 on the system to exit.
"CANCEL" will appear on the display.
Press ECO POWER/ STANDBY ON to exit
setting mode and go into ECO POWER
mode.
You can also press DISC, DISC1~3, DISC
CHANGE, OPEN•CLOSE to exit setting
mode and go into disc mode.
The system will also exit setting mode and go to
TUNER, TAPE or AUX/GAME mode when you
press the corresponding source button.
Viewing the clock in any source mode
When you have set the clock, press CLOCK on
the system to view clock (or press CLOCK/
TIMER on the remote control). Press
DISPLAY on the system to toggle between 12-
hour and 24-hour modes.
The time will be displayed for 5 seconds and
then go back to it's previous status.

Preparations

19