Figure 70. Installing the storage converter together with the solid-state drive into the storage drive bracket
5. Install the storage converter with the bracket into the desired storage drive bay. See "Primary hard disk
drive" on page 87 or "Secondary hard disk drive" on page 89.
6. Connect the signal cable and the power cable to the solid-state drive.
Replacing the solid-state drive
To replace the solid-state drive, do the following:
1. Prepare your computer. See "Preparing your computer and removing the computer cover" on page 55.
2. Locate the desired storage drive bay. See "Internal drives" on page 7.
3. Disconnect the signal cable and power cable from the solid-state drive.
4. Remove the storage converter with the solid-state drive from the storage drive bay. See "Primary hard
disk drive" on page 87 or "Secondary hard disk drive" on page 89.
5. Flex the sides of the plastic 3.5-inch storage drive bracket to remove the storage converter from the
bracket.
Figure 71. Removing the storage converter from the 3.5-inch storage drive bracket
92
P320 User Guide