Symbol PL470 Base Cradle Quick Reference page 8

P L 4 7 0
2. Seat the cables from the bottom of the cradle in the grooves
along the length of it so that the bottom of the cradle is
smooth and flat, as shown:
3. Secure two screws (included) to the wall. A template is
provided for you on page 12.
4. Fasten the screws into the wall where the cradle will hang,
leaving about 1/8" (.3 cm) of the screw outside the wall so that
the cradle will have something to hang on.
5. Place the cradle over the screw heads and slide down until it
fits into place. Slight pressure upwards should not move the
Preliminary
cradle.
6. Place the Phaser in the cradle.
B a s e
6
C r a d l e