Table of Contents
Advertisement
Mounting System Equipment
5
Mounting System Equipment
5.1
Mounting Controller Enclosures
5.1.1
Standard Enclosure
20
Siemens Building Technologies
Fire Safety & Security Products
The Controller is supplied in two enclosure variations (standard and hinged). Each
enclosure offers easy access and installation within a robust design.
The SPC standard enclosure is supplied with metallic cover. The cover is attached
to the base of the enclosure by two securing screws located on the top and bottom
of the front cover.
To open the enclosure, remove both screws with the appropriate screwdriver and
lift the cover directly from the base.
The standard enclosure contains the SPC Controller Printed Circuit Board (PCB)
mounted on four support pillars. An optional Input/Output module can be mounted
directly beneath the Controller PCB. A battery with capacity of 7AH (max) can be
accommodated below the SPC Controller.
An optional external antenna must be fitted to enclosures with metallic lid if the
wireless functionality* is required. If an antenna is fitted to the unit, it must be
enabled in the firmware.
The SPC standard enclosure provides three screw holes for wall mounting the unit.
To wall mount the enclosure, remove the cover and locate the initial fixing screw
hole at the top of the cabinet. Mark the position of this screw hole on the desired
location on the wall and drill the initial screw hole. Screw the unit to the wall and
mark the position of the bottom two screw hole positions with the unit vertically
aligned.
* Wireless features and devices will be available with a later market package.
09.2008
Advertisement
Table of Contents
