Electrical Alignment; Preparation; Required Equipment; Notes On Adjustments - Sony HDCU1000 Maintenance Manual

3-1. Preparation

3-1-1. Required Equipment

Measures
. Digital oscilloscope (300 MHz or higher)
Tektronix TDS460A or equivalent
. SD waveform/Vector monitor
Tektronix 1780R or equivalent (for NTSC)
Tektronix 1781R or equivalent (for PAL)
. SD signal generator
Tektronix TSG170A or equivalent (for NTSC)
Tektronix TSG271 or equivalent (for PAL)
. Audio oscillator
Tektronix SG-5010 or equivalent
. Frequency counter
Advantest TR5821AK or equivalent
Related equipment
. HDVS color video camera
HDC1000/1080/1500/1580
. Master setup unit
MSU-900/950
Tools
. Front extension board EX-982
(Sony P/N : A-1153-700-A)
. Rear extension board EX-983
(Sony P/N : A-1153-701-A)
. Extension board EX-984
(for SDP-12 board extension)
(Sony P/N : A-1153-715-A)
MM/HDCU1000 Series
Section 3

Electrical Alignment

3-1-2. Notes on Adjustments

. Make sure all the measures have already been calibrated.
. Make sure "3-1-4. Initialization Settings" have already
been finished.
. Make sure the adjustment of the HDC1500/1580 has
already been finished.
. Types of the color bars to be output from the built-in SG:
Signal format
HD-SDI
SD-SDI (D1)
SD-Component-analog
(HKCU1001)
SD-Composite-analog
(HKCU1001)
SD-Composite-analog
(HKCU1001)
. To adjust HDCU1000/1080/1500, extend each plug-in
board. Before pulling out the boards, be sure to turn off
the main power.
. Before starting adjustment, warm up for about 10
minutes.
. Before using the MSU-900/950, check the version of the
ROM. For details, refer to Section 1-1, "Checking the
ROM and Software Version" of the separate Installation
Manual for HDCU1000/1080/1500.
Y C
100 % 100 %
100 % 75 %
100 % 75 %
75 % 75 % (SMPTE)
100 % 75 % (EBU)
3-1 (E)