Mapping Queue To Dscp; Configuring Interface Remark - Cisco SF220-24 Administration Manual

Quality of Service
Workflow to Configure QoS Settings
STEP 1
STEP 2
STEP 3
STEP 4
STEP 1
STEP 2
STEP 3
STEP 4
Cisco 220 Series Smart Switches Administration Guide Release 1.1.0.x

Mapping Queue to DSCP

Use the Queues to DSCP page to remark DSCP value for egress traffic from each
queue.
To map queues to DSCP values:
Click Quality of Service > General > Queues to DSCP.
For each output queue, select the DSCP value to which egress traffic from the
queue is remarked.
Click Apply. The Running Configuration file is updated.
Click Restore Defaults to restore the queue to DSCP mappings to factory
defaults.

Configuring Interface Remark

Use the Remark Interface Settings page to remark the CoS/802.1p priority, IP
precedence, and DSCP value for egress traffic on a port. The CoS/802.1p priority
and IP or the CoS/802.1p priority and DSCP value can be remarked
simultaneously, but the DSCP value and IP cannot be remarked simultaneously.
To remark egress traffic on an interface:
Click Quality of Service > General > Remark Interface Settings.
Select the interface type (Port or LAG), and click Go.
Select an interface and click Edit.
Enter the following information:
• Interface—Select the port or LAG to be defined.
• Remark CoS—Check Enable to remark the CoS/802.1p priority for egress
traffic on this port or LAG.
• Remark IP Precedence—Check Enable to remark the IP precedence for
egress traffic on this port or LAG.
• Remark DSCP—Check Enable to remark the DSCP value for egress traffic
on this port or LAG.
18
257