Quality of Service
Workflow to Configure QoS Settings
STEP 3
STEP 4
STEP 1
STEP 2
STEP 3
STEP 4
STEP 1
STEP 2
STEP 3
STEP 4
Cisco 220 Series Smart Switches Administration Guide Release 1.1.0.x
Click Apply. DSCP values to queues are mapped, and the Running Configuration is
updated.
Click Restore Defaults to restore the DSCP to Queue mappings to factory
defaults.
Mapping Queues to CoS/802.1p
Use the Queues to CoS/802.1p page to remark the CoS/802.1p priority for egress
traffic from each queue.
To map queues to CoS values:
Click Quality of Service > General > Queues to CoS/802.1p.
For each output queue, select the CoS/802.1p priority to which egress traffic from
the queue is remarked.
Click Apply. The Running Configuration is updated.
Click Restore Defaults to restore the Queue to CoS/802.1p mappings to factory
defaults.
Mapping Queue to IP Precedence
To map egress queue to IP precedence:
Click Quality of Service > General > Queues to IP Precedence.
For each output queue, select the IP precedence to which egress traffic from the
queue is remarked.
Click Apply. The Running Configuration is updated.
Click Restore Defaults to restore the queue to IP precedence mappings to factory
defaults.
18
256