HP 6125XLG Layer 3-Ip Services Configuration Manual page 241

You must configure the tunnel source address and destination address at both ends of a tunnel, and
•
the tunnel source or destination address at one end must be the tunnel destination or source address
at the other end.
• HP recommends not configuring the same tunnel source and destination addresses for local tunnel
interfaces that use the same GRE encapsulation protocol.
If the destination address of a packet before encapsulation is not in the same subnet as the IP
•
address of the GRE tunnel interface, you must configure a route to the destination address of the
packet over the GRE tunnel interface. You can configure the route by using the following methods:
Configure a static route, using the destination address of the original packet as the destination
address of the route and the address of the local tunnel interface as the outgoing interface of the
route.
Enable a dynamic routing protocol on both the tunnel interface and the interface connecting the
private network, so the dynamic routing protocol can establish a routing entry with the tunnel
interface as the outgoing interface.
The IP address of the tunnel interface and the tunnel destination address configured on the tunnel
•
interface must be in different subnets.
You must create a service loopback group, specify its service type as tunnel, and add an unused
•
Layer 2 Ethernet interface to the service Loopback group. For more information about service
loopback groups, see Layer 2—LAN Switching Configuration Guide.
For information about tunnel interfaces, the interface tunnel, source, destination, and tunnel discard
ipv4-compatible-packet commands, and more configuration commands on a tunnel interface, see
"Configuring tunneling."
To configure a GRE over IPv6 tunnel:
Step
1. Enter system view.
2. Create a GRE over IPv6 tunnel
interface and enter its view.
3. Configure an IPv4 or IPv6
address for the tunnel
interface.
Command
system-view
interface tunnel interface-number
mode gre ipv6
For information about how to
assign an IPv4 address to an
interface, see "Configuring IP
addressing."
For information about how to
assign an IPv6 address to an
interface, see "Configuring basic
IPv6 settings."
230
Remarks
N/A
By default, the device has no
tunnel interface.
You must configure the same
tunnel mode on both ends of a
tunnel. Otherwise, packet delivery
might fail.
By default, no IPv4 or IPv6 address
is configured for a tunnel interface.
When the passenger protocol is
IPv4, configure an IPv4 address for
the tunnel interface. When the
passenger protocol is IPv6,
configure an IPv6 address for the
tunnel interface.