HP 6125XLG Layer 3-Ip Services Configuration Manual page 21

Figure 5 Network diagram
Configuration procedure
# Create VLAN 10.
<Switch> system-view
[Switch] vlan 10
[Switch-vlan10] quit
# Add Ten-GigabitEthernet 1/1/5, Ten-GigabitEthernet 1/1/6, and Ten-GigabitEthernet 1/1/7 to
VLAN 10.
[Switch] interface Ten-GigabitEthernet 1/1/5
[Switch-Ten-GigabitEthernet1/1/5] port access vlan 10
[Switch-Ten-GigabitEthernet1/1/5] quit
[Switch] interface Ten-GigabitEthernet 1/1/6
[Switch-Ten-GigabitEthernet1/1/6] port access vlan 10
[Switch-Ten-GigabitEthernet1/1/6] quit
[Switch] interface Ten-GigabitEthernet 1/1/7
[Switch-Ten-GigabitEthernet1/1/7] port access vlan 10
[Switch-Ten-GigabitEthernet1/1/7] quit
# Create VLAN-interface 10 and specify its IP address.
[Switch] interface vlan-interface 10
[Switch-vlan-interface10] ip address 192.168.1.2 24
[Switch-vlan-interface10] quit
# Create service loopback group 1 and specify the multiport ARP service for the group.
[Switch] service-loopback group 1 type multiport
# Assign Ten-GigabitEthernet 1/1/4 to service loopback group 1.
[Switch] interface Ten-GigabitEthernet 1/1/4
[Switch-Ten-GigabitEthernet1/1/4] port service-loopback group 1
[Switch-Ten-GigabitEthernet1/1/4] quit
# Configure a multiport unicast MAC address entry that has MAC address 00e0-fc01-0000, and output
interfaces Ten-GigabitEthernet 1/1/5, Ten-GigabitEthernet 1/1/6, and Ten-GigabitEthernet 1/1/7 in
VLAN 10.
Swtich
XGE1/1/5
XGE1/1/6
Server
Server group
192.168.1.1/24
00e0-fc01-0000
XGE1/1/7
Server
10
Server