Do not:
v Throw or immerse into water
v Heat to more than 100°C (212°F)
v Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
Note: For translations of this safety notice, refer to Safety Information.
Installing the ServeRAID controller
During the installation, you might need a small, flat-blade screwdriver.
To install the ServeRAID-4H or ServeRAID-4L controller:
Figure 37. Inserting a ServeRAID-4H controller into the PCI expansion slot
54
™
IBM TotalStorage
Network Attached Storage 200 Installation Guide
1. Review the Safety Information book provided with your appliance.
2.
Switch off the appliance and disconnect all power cords and cables from the
appliance.
3. Remove the appliance cover.
4. Remove the expansion-slot cover.
5. Touch the static-protective package containing the controller to an unpainted
metal expansion-slot cover on the appliance. This discharges any static
electricity from the package and from your body.
6. Remove the controller from the static-protective package holding the controller
by the edges. Do not touch any exposed components on the controller.
7. Insert the controller in the PCI expansion slot. Press the controller firmly into
the slot so that it is fully seated.