Using The Remote Control - Epson BrightLink 695Wi Getting Started

Using the Remote Control

Turn projector
on/off
Access menu
system for additional
adjustments
Calibrate
Page through
documents
Temporarily
turn off image
and sound
For more information on using the remote control:
• See the online BrightLink User's Guide
• Watch a video or two at
www.epson.com/brightlinkvideos (U.S.) or
www.epson.ca/brightlinkvideos (Canada)
Calibration
Calibration coordinates the position of the pen or your
finger with the location of your cursor. If the pen or
finger position and cursor location don't match, you can
perform auto calibration, or you can calibrate manually for
even greater accuracy.
Note: You must perform pen calibration before calibrating
finger touch.
Pen Calibration
1
To start pen calibration, press the User button on
the remote control, or press the Home button on the
remote control and select Auto Calibration.
2
Select from various
image sources
connected to the
projector
3
4
Switch between
PC Interactive and
5
PC Free Annotation
Enter
Finger Touch Calibration
Zoom in and out
Note: If you are unable to perform finger touch calibration,
make sure that the installer properly installed the Touch
Unit and performed the angle adjustment.
Stop video action
Display Home
1
screen
2
3
4
5
6
7
For more detailed instructions, see the online BrightLink
User's Guide.
When you see the Auto Calibration screen, do one of
the following:
• Press to run auto calibration, then wait until
calibration is complete.
• Select No, then press
below to calibrate manually.
Select Manual Calibration, then press
When you see the Manual Calibration screen, press
to select Yes.
Touch the center of the circles on the screen with
your pen to perform manual calibration.
To start finger touch calibration, press the User
button on the remote control, or press the Home
button and select Auto Calibration.
When you see the Auto Calibration screen, select
No, then press and follow the steps below.
Select Touch Unit Setup, then press
Select Touch Calibration, then press
When you see the Touch Calibration screen, press
to select Yes.
A green circle appears in the upper left corner of
your projected image.
Touch and hold the center of the circle with your
finger until the circle disappears and another one
appears.
Note: Make sure you touch the center of each circle;
otherwise the calibration may not be accurate.
Continue until all of the circles disappear.
and follow the steps
.
.
.