Identification Data Of The Device - Siemens simatic ipc227e Operating Instructions Manual

3.1.2

Identification data of the device

The device can be clearly identified with the help of this identification data in case of repairs
or theft.
Enter the identification data in the following table:
Order number
Serial number
Production version
Windows "Product Key"
Ethernet address 1 (MAC)
Ethernet address 2 (MAC)
Obtain the data from the rating plate and COA label. The rating plate is located on the back
panel of the device. The COA label is only available in pre-installed Windows operating
systems and is affixed to the rear of the device.
Procedure
1. Transfer order number, serial number, production version (FS), and Ethernet addresses
from the rating plate.
The Ethernet addresses can also be found in the BIOS Setup under "Main > Advanced >
Peripheral Configuration" (see section "Technical Specifications").
Replacement device: On the rating plate, the order number of a replacement device
which is available from stock at short notice is listed under "Spare Part Space Units". The
replacement device is always supplied without storage media.
Note
Replacement device without storage media
When you order a replacement device, remove all the storage media from your device,
for example SSD. Insert the storage media into the replacement device.
2. Transfer the Windows "Product Key" from the COA label.
SIMATIC IPC227E
Operating Instructions, 11/2016, A5E35782395-AB
Installing and connecting the device
3.1 Preparing for installation
6ES ...
S VP
FS
27