Test Report - GE Advisor MASTER ATS111 series Manager Manual

6. Test report

Use this function to display the results of the Disarm Test or Arm Test.
Disarm test report: The test results to see if specific zones and cameras are operating correctly. The zones need to be
programmed to be included in the test, and operate when areas are disarmed. All cameras are
tested.
The results of the camera tests are only displayed if the user doing the disarm test has been
programmed to test cameras. Also, Area 1 must be assigned to this user's alarm group when the
user is testing Area 1.
Arm test report: The test results to see if specific zones are operating correctly. The zones need to be programmed
to be included in the test, and operate when areas are armed.
Where a zone is displayed as untested, it could mean that it has not been tested because it was missed, or because it was
faulty and could not be tested.
To display the results of a test
1. Access menu option 6.
The display shows:
2. Select the test report you want by pressing:
•
1 [ENTER] for Disarm Test, or
•
2 [ENTER] for Arm Test, or
•
[ENTER] to return to the menu.
3. What happens next depends on which option you chose and whether there are untested zones/cameras:
•
Disarm test: (Zone test report is shown first).
All zones tested successfully
No Untested Zones
Press ENTER
All cameras tested successfully
(press ENTER to display)
All Cameras Have Tested Successfully
Press Enter
4. From the display you can now:
Test Report: 1-Disarm 2- Arm
Option:
Untested zones
Untested zones are listed either one at a time, or as a list of
numbers:
or
Untested cameras
(press ENTER to display)
Untested Disarm On 25, Reception Hold UP
NEXT or ENTER
Untested Disarm On 25, 26, 27.
Zone No:
Untested Arm On 17, Rear Door Contact
NEXT or ENTER
33