D Functions For The Rtty Decoder Indication - Icom IC-7600 Instruction Manual

D Functions for the RTTY decoder indication

q Push a band key to select the desired band.
w Push [RTTY/PSK] to select RTTY.
• After RTTY mode is selected, push and hold [RTTY/
PSK] for 1 sec. to toggle between RTTY and RTTY-R
modes.
• "RTTY" or "RTTY-R" appears.
e Push [DECODE] (F-3) to display the decode
screen.
• When tuned into an RTTY signal, decoded characters
are displayed in the RX contents screen.
r Push [HOLD/CLR] (F-2) to freeze the current
screen.
• " " appears while the function is in use.
• Push [HOLD/CLR] (F-2) again to cancel the function.
t Push [WIDE] (F-6) to toggle the RTTY decode
screen size from normal and wide.
• S/RF meter type during wide screen indication can be
selected in display set mode.
y Push and hold [HOLD/CLR] (F-2) for 1 sec. to
clear the displayed characters.
•
" " indicator disappears at the same time when
the hold function is in use.
u Push [EXIT/SET] to close the RTTY decode
screen.
D Setting the decoder threshold level
Adjust the RTTY decoder threshold level if some
characters are displayed when no signal is received.
q Select the RTTY decode screen as described
above.
w Push [ADJ] (F-4) to select the threshold level set-
ting condition.
e Rotate the main dial to adjust the RTTY decoder
threshold level.
• Push and hold [DEF] (F-5) for 1 sec. to select the
default setting.
r Push [ADJ] (F-4) to exit from the threshold level
setting condition.
The UnShift On Space (USOS) function and new
line code can be set in the RTTY set mode.
(p. ??)
(pgs. ??, ??)
RECEIVE AND TRANSMIT
DECODE
F-3
F-2 RTTY/PSK
HOLD/CLR
• Wide screen indication
4
WIDE
Band keys
F-6
EXIT/SET
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
48