Arming - Honeywell Apex Destiny 4100 User Manual

A RMIN G
When referring to operation from a phone, the following
instructions will assume that access to the system has already
taken place. Remember, your installer has programmed a one
to four digit code which you will enter when you pick up the
phone to get access to the system.
How to TURN ON the alarm system to provide protection:
1. Arming the system to AWAY:
*
or A key.
Push the
If no zones are open, the green AWAY LED will light
and the system will say “ARMED TO AWAY” over the
phone or through the speaker.
The security system is now on, or armed. When armed in
the AWAY mode, all interior zones, including motion
detectors, become active, as well as all perimeter zones.
If any zone is open while attempting to arm the system,
the AWAY LED will not light and the system will say
“ZONES OPEN” over the phone or through the speaker,
indicating that the system did NOT arm because a
window or door is OPEN.
See “Force Arm” to continue to arm.
After you have ARMED the system, you must leave
through the designated entry/exit door within the
specified exit delay time. Your installer can program
the exit delay time you desire.
NOTE: If a zone is opened before the exit delay
expires, or the system is force armed, then that zone
will not be part of the system until that zone is closed.
2. Arming the system to HOME:
Push the # or H key.
If no zones are open, the red HOME LED will light and
you will hear the system say “ARMED TO HOME” over
the phone or through the speaker.
The security system is now on, or armed. When armed
to the HOME mode, only the exterior, or perimeter,
zones are armed. This will allow you to move about
freely within your home. If any zone is open while
attempting to arm the system, the HOME
ARMIN G
A RMIN G THE
SYSTEM T O
A W A Y:
*
PUSH THE O R A
KEY.
N O TE:
A RMIN G THE
SYSTEM T O H O ME:
PUSH THE # O R H
KEY.
9