Honeywell VISTA-128BPT Installation And Setup Manual page 7

Item Feature
Zone Abort Window (for non-
Programming fire zones)
(Abort Window
Enable)
Zone Swinger Suppression
Programming Enable
(Swinger
Suppression
Enable)
Zone Fire Alarm Verification
Programming
Tamper Option
- Exit Time and Progress
Annunciation/Disable
for Remote Arm (Not
Evaluated for SIA CP-
01)
- Programmable Cross
Zoning Time
- Cancel Window
- Cancel Annunciation -
Keypad displays "Alarm
Cancel" when report is
received
User Authority Duress Feature
Level 6
* Programming at installation may be subordinate to other UL requirements for the intended application.
** Combined Entry Delay and Abort Window should not exceed 1 minute.
NOTES:
•
Using the Call Waiting Cancel feature on a non-Call Waiting line will prevent successful communication to the
central station.
•
The control unit must be installed with a local sounding device and an off-premise transmission for Contact ID
communication format.
•
Refer to the User Guide for procedures on Testing the System.
•
During Test mode, no alarm reports are sent to the central monitoring station.
SECTION 1: CONVENTIONS USED IN THIS
Range
0 = no abort
window
1 = yes, use abort
window according
to ∗88 selection
0 = no suppression
1 = yes, suppress
alarms according to
∗84 selection
For Zone Response
Type 16 (Fire)
tamper selection
must be set to "0"
Always Enabled
Both zones must be
faulted within 5
minutes
5 minutes
NA
NA
1-3
Shipping SIA Requirement*
Default
1 = yes Yes (all non-fire
zones)
Yes (enabled) Yes (enabled (all
zones))
Disabled Enabled unless
sensors can
self-verify
Enabled Enabled
Per Per walk path in
Manufacturer protected premises
Enabled Not required to be
programmable
Enabled Enabled
Disabled Disabled
MANUALL