Table of Contents
Advertisement
Wiring works
Selection for the power and booster heater wire terminal
f Connect the cables to the terminal board using the solderless ring terminal .
f
f Use certified and verified cables .
f
f Connect using a driver which is able to apply the rated torque to the screws .
f
f If the terminal is loose, fire may occur caused by arc .
f
If the terminal is connected too firmly, the terminal may be damaged .
f External force should not be applied to the terminal block and wires .
f
f The cable ties to fasten the wire should be an incombustible material, V0 or above .
f
(The cable ties should be used to fasten the power wire and they are supplied with the unit . )
Tightening Torque(kgf•cm)
M3 . 5
M4
M5
f Main PCB
f
M4 Screw
f ELCB
f
M5 Screw
10
EHS Control unit_MIM-E03@_IM_E_34413-2.indd 10
8 ~ 10
12 ~ 15
20 ~ 25
M3 . 5 Screw
M3 . 5 Screw
2012-04-05 오후 1:19:58
Advertisement
Table of Contents
