JVC KS-FX621 Service Manual page 11

QQ
3 7 63 1515 0
2.2.10 Disassembling the flywheel assembly (F)
(See Fig.20 and 21)
(1) Push and turn counterclockwise the spring holder (F) to re-
lease the three joints p on the bottom of the flywheel.
(2) The spring holder (F), the TU spring and the friction gear
play come off.
(3) Remove the polywasher and felt.
Flywheel assembly (F)
Joints p
2.2.11 Disassembling the flywheel assembly (R)
(See Fig.20 and 22)
(1) Push and turn clockwise the spring holder (R) to release
the three joints q on the bottom of the flywheel.
(2) The spring holder (R), the FF spring and the friction gear
FF come off.
(3) Remove the polywasher and the felt.
TE
L 13942296513
Spring holder (R)
Friction gear FF
Flywheel assembly (R)
2.2.12 Removing the reel board
(See Fig.23 and 24)
(1) Remove the two screws C attaching the reel board.
(2) Move the reel board in the direction of the arrow to release
the joint r.
(3) Unsolder the wires if necessary.
CAUTION:
When reattaching, confirm operation of the MODE switch and
the ST-BY switch.
www
The mode position between EJECT and ST-BY is optimum for
reattaching.
Connect the card wire extending from the reel board to the
.
FFC pad before reattaching the reel board.
http://www.xiaoyu163.com
Flywheel assembly (R)
Joints q
Joint q
Joint p
Fig.20
Polywasher
FF spring
Felt
Fig.22
x ao u163
y
i
http://www.xiaoyu163.com
2 9
8
C
Q Q
3 6 7 1 3 1 5
co
.
9 4 2 8
Polywasher
Spring holder (F)
TU spring
Friction gear play
Felt
Flywheel assembly (F)
Fig.21
FFC pad
0 5 8 2 9 9 4 2 8
Joint r
Reel board
C
Fig.23
FFC pad
CT-1 switch
m
MODE switch
ST-BY switch
Soldering
Fig.24
(No.49825)1-11
KS-FX621
9 9
9 9