JVC KS-FX621 Service Manual page 10

KS-FX621
QQ
3 7 63 1515 0
2.2.8 Removing the head / tape guide
(See Fig.16 and 17)
REFERENCE:
It is not necessary to remove the slide chassis assembly.
(1) Remove the band attaching the wire to the head.
(2) Remove the two screws B, the head and the head support
spring.
(3) Remove the pinch arm spring from the tape guide.
(4) Remove the tape guide and the pinch spring arm.
CAUTION:
When reattaching the pinch arm spring, set both end of it to the
pinch spring arm ( remarked o).
CAUTION:
When reattaching the head, set the wires into the groove of the
tape guide (Fig.16).
Slide chassis assembly
TE
L 13942296513
2.2.9 Removing the flywheel assembly (F) & (R)
(See Fig.18 and 19)
REFERENCE:
It is not necessary to remove the slide chassis assembly.
(1) Remove the belt at the bottom.
(2) Remove the two polywashers on the upper side.
(3) Pull out each flywheel assembly downward.
Flywheel assembly (F)
Flywheel assembly (R)
www
1-10 (No.49825)
http://www.xiaoyu163.com
B
Head
Tape guide
Fig.16
Belt
Fig.18
x ao
y
. i
http://www.xiaoyu163.com
8
Head
Head support spring
Tape guide
o
Pinch spring arm
Slid chassis assembly
Q Q
3 6 7 1 3
Flywheel assembly (F)
u163
.
2 9 9 4 2 8
B
Pinch arm spring
o
1 5 Fig.17 0 5 8 2 9 9 4
Polywasher
Polywasher
Flywheel assembly (R)
Fig.19
m
co
9 9
2 8 9 9