Wall Mounting - Panasonic KX-NS0154 Quick Installation Manual

3 Installing the IP-CSs

3.3 Wall Mounting

Mounting
WARNING
•
Make sure that the wall that the unit will be attached to is strong enough to support the unit
(approx. 330 g). If not, it is necessary for the wall to be reinforced.
•
Only use the wall-mounting equipment included with the unit.
•
When the unit is no longer in use, make sure to detach it from the wall.
CAUTION
•
When driving the screws into the wall, be careful to avoid touching any metal laths, wire laths or metal
plates in the wall.
•
Do not stretch or bend the cables. Also, do not allow anything to rest on the cables.
•
Use cables that are fire-resistant or fireproof.
•
The unit and the cables should never be placed near or over a radiator or other heat source.
•
Do not bundle cables that are connected to the unit with the AC power cords of machines located
nearby.
•
Make sure the cables are securely fastened to the wall.
Notice
Panasonic assumes no responsibility for injuries or property damage resulting from failures arising out of
improper installation or operation inconsistent with this documentation.
1.
Place the reference for wall mounting on the wall to mark the 2 screw positions.
2.
Install the 2 screws and washers (included) into the wall.
Note
•
Make sure that the screw heads are at the same distance from the wall.
•
Install the screws perpendicular to the wall.
3.
Insert the upper and lower tabs of the wall mounting plate into the designated openings in the unit.
4.
Pass the AC adaptor cord and LAN cable through the hole of the wall mounting plate.
5.
Slide the wall mounting plate in the direction of the arrow until it clicks.
6.
Hook the unit on the screw heads.
12 Quick Installation Guide