Oil Change Indicator Reset; Engine Coolant Check - Ford Taurus2017 Owner's Manual

Note: Make sure you install the oil filler cap
correctly.
Note: Soak up any spillage with an
absorbent cloth immediately.
OIL CHANGE INDICATOR
RESET
Use the information display controls on
the steering wheel to reset the oil change
indicator.
From the main menu scroll to:
Message Action and description
Settings Press the right arrow button,
then from this menu scroll
to the following message.
Vehicle Press the right arrow button,
then from this menu scroll
to the following message.
Oil Life Press the right arrow button,
then from this menu scroll
to the following message.
Hold OK to Press and hold the OK
Reset button until the instrument
cluster displays the
following message.
Reset Successful
When the oil change indic-
ator resets the instrument
cluster displays 100%.
Remaining Life
{00}%
Taurus (CPH) Canada/United States of America, enUSA, First Printing
Maintenance
Message

ENGINE COOLANT CHECK

Do not remove the coolant reservoir
cap when the cooling system is hot.
Wait 10 minutes for the cooling
system to cool down. Cover the coolant
reservoir cap with a thick cloth to prevent
the possibility of scalding and slowly
remove the cap. Failure to follow this
instruction could result in personal injury.
Do not put coolant in the windshield
washer fluid reservoir. If sprayed on
the windshield, coolant could make
it difficult to see through the windshield.
To reduce the risk of personal injury,
make sure the engine is cool before
unscrewing the coolant pressure
relief cap. The cooling system is under
pressure. Steam and hot liquid can come
out forcefully when you loosen the cap
slightly.
Do not add coolant further than the
MAX mark.
When the engine is cold, check the
concentration and level of the coolant at
the intervals listed in the scheduled
maintenance information. See Scheduled
Maintenance (page 447).
Note: Make sure that the coolant level is
between the MIN and MAX marks on the
coolant reservoir.
243
Action and description
If the instrument cluster
displays one of the following
messages, repeat the
process.
Not Reset
Reset Cancelled
WARNINGS