Cisco ASR 903 Troubleshooting Manual page 25

Troubleshooting
LED Label
Operating Status (STAT)
68-Pin Connector LEDs
12-in-1 Connector LEDs
E and M Interface Module LEDs
The table below summarizes the LEDs for the E & M interface module.
Table 26: Cisco ASR 903 Router EandM IM LEDs
LED Label
Power (PWR)
Color/State
Red
Yellow
Green
Off
Green
Blinking Green
Solid Yellow
Blinking Yellow
Off
Green
Solid Yellow
Blinking Yellow
Off
Color/State
Green
Red
Off
Cisco ASR 903 Aggregation Services Router Hardware Installation Guide
Interface Module LEDs
Meaning
Failure
Booting (if IM has a local CPU)
Operational
No Power
At least one of the 4 ports is in an
up state.
At least one of the 4 ports is
passing traffic
All four ports are successfully
initialized and in a down state
At least one of the port has failed
All the ports are not enabled (at
POR)
Port is passing traffic
Port successfully initialized and in
a down state
Port has failed
Not Enabled (at POR)
Description
All power rails are within spec.
Disabled
No Power
25