Checking The Scsi Id - Sony PBD-D50 Operating Instruction

To set the SCSI
terminator
It is not necessary to set
the SCSI terminator
because the SCSI
terminator of this unit is
always "ON."
14

1 Checking the SCSI ID

Before connecting to your PC, it is necessary to set the
SCSI ID using the DIP switch on the rear panel of the
unit to prevent an overlap with the other units
connected to your PC.
Change the default setting using a pointed object such
as the tip of a ballpoint pen.
If your PC is connected to one or more other units
using SCSI ID numbers, you cannot use the same SCSI
ID number for more than one unit.
The default number of the SCSI ID of this unit is "3."
2 1 0
ON
OFF
SCSI ID
0
1
2
3
4
5
6
1)
7
1) The default number of the SCSI ID of the PC is usually "7."
Therefore you need to use "0" to "6" to set the SCSI ID of
this unit.
Switch number
2 1
OFF OFF
OFF OFF
OFF ON
OFF ON
ON OFF
ON OFF
ON ON
ON ON
0
OFF
ON
OFF
ON
OFF
ON
OFF
ON