Transmission Oil
Oil in the transmission deteriorates and its lubrica
tion performance decreases if it is used too long.
It should therefore be changed periodically.
To change:
1) Remove the oil filler cap and oil drain plug
located on the bottom of the engine and drain
the transmission case.
Note:
If possible, do this while the engine is
warm and the oil viscosity is low.
2) Reinstall the drain plug
(!) Oil filler cap
Drain plug
3) Measure 500 cc (1.06/0.88 US/Imp pt) of the
recommended oil (See page 7.) in a measuring
beaker and pour it into the transmission cham
ber slowly.
16
Measuring beaker
4) Refit the oil filler cap.
Clutch
Clutch adjustment is made in two stages, i.e., ad
justment of play in the clutch cable and the clutch
release mechanism.
CD Clutch cable adjuster
2) Loosen the release screw locking nut temporari
ly with a 10 mm open end wrench and turn in
the release adjusting screw until it stops slightly
and then back it out � turn.
CD Release adjusting screw
3) Secure the release screw locking nu t.