Verifying the IPv6 Configuration
S e n d d o c u m e n t c o m m e n t s t o n e x u s 7 k - d o c f e e d b a c k @ c i s c o . c o m .
Verifying the IPv6 Configuration
To verify configuration information, use the following commands:
Command
show hardware forwarding ip verify
show ipv6 interface
show ipv6 adjacency
show ipv6 icmp
show ipv6 nd
show ipv6 neighbor
IPv6 Example Configuration
This example shows how to configure IPv6:
config t
interface ethernet 3/1
ipv6 address dc3:dc3::/64 eui64
ipv6 nd reachable-time 10
Default Settings
Table 3-5
Table 3-5
Parameters
ND reachable time
neighbor solicitation retransmit interval
Additional References
For additional information related to implementing IPv6, see the following sections:
•
•
Cisco Nexus 7000 Series NX-OS Unicast Routing Configuration Guide, Release 4.x
3-24
lists the default settings for IPv6 parameters.
Default IPv6 Parameters
Related Documents, page 3-25
Standards, page 3-25
Purpose
Displays the IPv4 and IPv6 packet verification
configuration.
Displays IPv6 related interface information.
Displays the adjacency table.
Displays ICMPv6 information.
Displays IPv6 neighbor discovery interface information.
Displays IPv6 neighbor entry.
Default
0 milliseconds
1000 milliseconds
Chapter 3
Configuring IPv6
OL-20002-02