Displaying The Zero Offset "Overview - Siemens SINUMERIK 840D sl Operating Manual

Setting up the machine
4.5 Zero offsets
4.5.3

Displaying the zero offset "overview"

The active offsets or system offsets are displayed for all set-up axes in the "Work Offset -
Overview" window.
In addition to the offset (course and fine), the rotation, scaling and mirroring defined using this
are also displayed.
This window is generally used only for monitoring.
Display of active work offsets
Work offsets
DRF
Rotary table reference
Basic reference
External WO frame
Total base WO
G500
Tool reference
Workpiece reference
Programmed WO
Cycle reference
GFRAME0 (seat-related
work offset)
Total WO
Procedure
78
Displays the handwheel axis offset.
Displays the additional work offsets programmed with $ P_PART‐
FRAME.
Displays the additional work offsets programmed with $P_SETFRAME.
Access to the system offsets is protected via a keyswitch.
Displays the additional work offsets programmed with $P_EXTFRAME.
Displays all effective basis offsets.
Displays the work offsets activated with G54 - G599.
Under certain circumstances, you can change the data using "Set WO",
i.e. you can correct a zero point that has been set.
Displays the additional work offsets programmed with $P_TOOLFRAME.
Displays the additional work offsets programmed with $P_WPFRAME.
Displays the additional work offsets programmed with $P_PFRAME.
Displays the additional work offsets programmed with $P_CYCFRAME.
Displays the additional work offsets programmed with $P_GFRAME.
Displays the active work offset, resulting from the total of all work offsets.
1. Select the "Parameter" operating area.
2. Press the "Work offset" and "Overview" softkeys.
The "Work offset - Overview" window opens.
Operating Manual, 05/2017, A5E40869190
Grinding