Samsung PPM63M7FS Service Manual page 43

Troubleshooting
4-2-4 Service Adjustment
■ Color Calibration
Adjust spec.
1. Source: Component
2. Setting Mode: 1920x1080@60hz
3. Pattern: Pattern #24 (Chess Pattern)
4. use equipment : Ca210 & Master MSPg925 generator
※It is no Calibration necessuty in DVI, aV, PC mode
※use other equipment only after comparing the result with that of the Master equipment.
Input mode
Component IN (Model_#6)
■ Method of Color Calibration (Component)
1) Apply the 1080p Lattice (N0. 6) pattern signal to the Component IN 1 port
2) Press the Source key to switch to "Component1" mode
3) Enter Service mode
4) Select the "Calibration" menu
5) Select the "Comp Calibration" menu.
6) In "Comp Calibration Off" status, press the " " key to perform Calibration.
7) When Calibration is complete, it returns to the high-level menu.
8) You can see the change of the "Comp Calibration" status from failure to Success.
4-22
- You must perform Calibration in the Lattice Pattern before adjusting the White Balance
Calibration
Perform in 1080p B&W Pattern #24
<Table 1>
( Chess Pattern )
Pattern
Lattice
Samsung Electronics
.