Setting Spool Pins; Removing Or Inserting The Bobbin Case - Janome 2200XT Instruction Manual

Setting Spool Pins

The spool pins are used for holding the spool of
thread in order to feed thread to the machine.
To use, pull up the spool pin. Push down for stor­
age.
CD
Upper thread
@ Hole
® Tangle
Note:
When using thread which has tendency to
tangle around spool pin, thread through the hole
of spool pin as shown.
The hole should face the thread spool.

Removing or Inserting the Bobbin Case

Open the hook cover.
CD
Hook cover
Raise the needle by turning the handwheel toward
you. Take out the bobbin case by holding the latch.
@ Latch
When inserting the bobbin case, place the horn
into the recess of the hook race.
® Horn
6