ResMed AirMini Patient Manual page 13

Problem/possible cause
Air pressure in my mask seems too low or it feels like I am not getting enough air.
Ramp may be in progress.
The HumidX or vent might be blocked.
The HumidX may be wet.
I cannot start therapy.
Power may not be connected.
My therapy has stopped.
The air tubing may be disconnected.
You may be experiencing high mask leak while the
SmartStop feature is enabled.
I cannot scan the QR code to pair my AirMini machine.
The camera is not focused or broken, or the QR code label is
damaged.
The QR code label is unreadable.
The light above the Start/Stop button is flashing green.
An error has occurred on the AirMini machine.
12
Solution
Use the AirMini app to confirm that the Ramp Time comfort
feature has been enabled. If so, wait for air pressure to build
up or turn off the Ramp Time feature using the AirMini app.
Inspect the HumidX and vent for blockages or damage. Refer
to your AirMini user guide for information on cleaning and
maintenance.
The HumidX should be dry when starting therapy. Determine
whether the HumidX is wet and replace it if necessary.
Connect the power supply unit and ensure that the plug is
fully inserted. The green indicator light on the power supply
unit should be illuminated.
Ensure that the green indicator light above the Start/Stop
button on the AirMini machine is also illuminated.
Ensure that the air tubing is properly connected. Press the
Start/Stop button on the AirMini machine to continue
therapy.
Ensure that your mask is fitted correctly. Refer to your mask
user guide for fitting instructions or perform the mask fit
function using the AirMini app to check your mask fit and
seal.
Alternatively, disable the SmartStop feature.
Pair your AirMini machine manually by entering into your
smart device the four-digit key found on the back of your
machine.
Contact your provider.
Unplug your AirMini machine. Wait a few seconds and then
plug it back in.
If the problem persists, contact your provider. Do not open the
AirMini machine.