To Prevent A Deterioration In The Voice Recognition Rate/Voice Quality; Security Setting (Type A) (Bluetooth); Password Setting (Bluetooth); Using Bluetooth Hands-Free With A Password - Mazda 6 Owner's Manual

To prevent a deterioration in the voice
recognition rate and voice quality, the
following points should be observed:
The voice recognition cannot be
performed while voice guidance or
the beep sound is operating. Wait
until the voice guidance or the beep
sound is nished before saying your
commands.
Dialects or different wording other
than hands-free prompts cannot be
recognised by voice recognition. Speak
in the wording speci ed by the voice
commands.
It is not necessary to face the
microphone or approach it. Speak the
voice commands while maintaining a
safe driving position.
Do not speak too slow or too loud.
Speak clearly, without pausing between
words or numbers.
Close the windows to reduce loud
noises from outside the vehicle, or turn
down the air ow of the air-conditioning
system while Bluetooth
being used.
Make sure the vents are not directing air
up towards the microphone.
NOTE
If the voice recognition performance is
not satisfactory.
Refer to Voice Recognition Learning
Function (Speaker Enrolment) (Type A)
on page 5-105 .
Refer to Troubleshooting on page
5-144 .
Hands-Free is
®
Security Setting (Type A)
If a password is set, the system cannot be
activated unless the password is input.
NOTE
Do this function only when parked. It is
too distracting to attempt while driving
and you may make too many errors to
be effective.
Password setting
1. Press the pick-up button or talk button
with a short press.
2. Say: [Beep] "Setup"
3. Prompt: "Select one of the following:
Pairing options, con rmation prompts,
language, password, select phone or
select music player."
4. Say: [Beep] "Password"
5. Prompt: "Password is disabled. Would
you like to enable it?"
6. Say: [Beep] "Yes"
7. Prompt: "Please say a 4-digit
password. Remember this password. It
will be required to use this system."
8. Say: [Beep] "XXXX" (Say a desired
4-digit password, "PCode".)
9. Prompt: "Password XXXX (Password,
PCode). Is this correct?"
10. Say: [Beep] "Yes"
11. Prompt: "Password is enabled."
Using Bluetooth
®
password
1. Press the pick-up button or talk button
with a short press.
2. Prompt: "Hands-Free system
is locked. State the password to
continue."
3. Say: [Beep] "XXXX" (Say the set
password "PCode".)
Interior Features
Bluetooth
Hands-Free with a
5–103
®