Table of Contents
Advertisement
INSTRUMENTS AND CONTROLS
||
for security purposes. See the article "Program-
ming HomeLink."
Related information
•
Programming the HomeLink
trol System* (p. 164)
164
Programming the HomeLink
Wireless Control System*
NOTE
®
Wireless Con-
Some vehicles may require the ignition to be
switched on or be in the "accessories" posi-
tion for programming and/or operation of
HomeLink. It is also recommended that a new
battery be placed in the hand-held transmitter
of the device being programmed to Home-
Link for quicker training and accurate trans-
mission of the radio-frequency signal. The
HomeLink buttons must be reset first. When
this has been completed, Homelink is in
learning mode so that you can perform pro-
gramming.
To program HomeLink
1. Press the HomeLink
grammed. The HomeLink
begin flashing yellow once a second. You do
not need to continue holding the button.
2. Point the hand-held transmitter toward the
HomeLink
hold it approx. 6–12 inches (15–30 cm)
away from the HomeLink
obstruct the HomeLink
®
®
®
button to be pro-
®
indicator will
®
button to be programmed and
®
button. Do not
®
indicator light.
3. Press and hold the button on the original
remote control that is to be programmed on
®
HomeLink
and observe the HomeLink
indicator light. Hold the button until the indi-
cator light has changed from flashing yellow
once a second to either flashing green 10
times a second or by glowing steadily green.
®
When the HomeLink
indicator light flashes
or glows steadily green, the button on the
original remote control can be released.
Note: for certain remote controls, the
instructions listed under "Gate operators/
Canadian programming" at the end of this
article should be used instead of step 3.
®
* Option/accessory.
Advertisement
Table of Contents
