Using The Vocoder In Performance Mode; When The Perfmode Is "Dual - Roland System-8 Reference Manual

Using the Vocoder in Performance Mode

1
[PERFORMANCE]
Press the MODE
2
[VOCODER]
Press the
3
While vocalizing into the input (Microphone), play the keyboard.
You can perform the vocoder sound that's generated according to the currently selected patch and the input audio.
5 Input settings including the vocoder settings can be made and stored for each individual performance.
5 Input settings including the vocoder operate differently depending on the setting of the
If this is set to "PERFORM,"
"SYSTEM,"
If this is set to
5 The part used as the vocoder's carrier can be specified and remembered for each performance by the
Carrier" parameter.

When the PerfMode Is "DUAL"

When the PerfMode (p. 14) is set to
5 When you turn the
[VOCODER]
The input (Microphone) audio is not output.
The audio of the upper part and lower part patches is output according to the on/off status of the PART ON/OFF
buttons.
5 If you want to play only the vocoder sound, press the PART ON/OFF
SYSTEM setting
INPUT
INPUT: Gain
PERFORMANCE MODE
UPPER PART
LOWER PART
button to select performance mode.
"on"
button to turn it (lit).
the performance settings are used. The
the system settings are used. The
"DUAL,"
operation is as follows.
button "on,"
[INPUT]
PEAK LED
knob
PATCH
PATCH
PART
ON/OFF
[UPPER]
[LOWER]
Button
"PERFORM EDIT: INPUT: Prm Src"
[VOCODER] button's on/off status is also remembered.
[VOCODER]
button's on/off status is not remembered.
[UPPER] [LOWER] buttons to make them go dark.
[VOCODER]
button
VOCODER
PERF EDIT
INPUT (Voc): Carrier
Using the Vocoder (VOCODER)
parameter.
"PERFORM EDIT: INPUT (Voc):
[UPPER] [LOWER]
DELAY
CHORUS
REVERB
OUTPUT
33