Table of Contents
Advertisement
SuperServer 1028GQ-TR(T) User's Manual
sSATA Port 0-Port 3 sSATA Device Type
Use this item to specify if the sSATA port specified by the user should be
connected to a Solid State drive or a Hard Disk Drive. The options are Hard
Disk Drive and Solid State Drive.
*If the item above "Configure sSATA as" is set to IDE, the following items will
display:
sSATA Port 0-Port 3
This item indicates that an sSATA port specified by the user is installed (present)
or not.
sSATA Port 0 ~ Port 3 sSATA Device Type (Available when a SATA port is
detected)
Use this item to specify if the sSATA port specified by the user should be
connected to a Solid State drive or a Hard Disk Drive. The options are Hard
Disk Drive and Solid State Drive.
*If the item above "Configure sSATA as" is set to RAID, the following items will
display:
Support Aggressive Link Power Management
When this item is set to Enabled, the SATA AHCI controller manages the power
usage of the SATA link. The controller will put the link to a low power state when
the I/O is inactive for an extended period of time, and the power state will return
to normal when the I/O becomes active. The options are Disabled and Enabled.
sSATA RAID Option ROM/UEFI Driver
Select EFI to load the EFI driver for system boot. Select Legacy to load a legacy
driver for system boot. The options are Legacy, EFI, and Disabled.
SATA/sSATA RAID Boot Select
Select SATA Controller to use a device supported by the SATA connector for
system boot. Select sSATA Controller to use a device supported by the sSATA
connector for system boot. The options are None, SATA Controller, sSATA
Controller, and Both.
sSATA Port 0-Port 3
This item displays the information detected on the installed sSATA drives on
the particular sSATA port.
•
Model number of drive and capacity
•
Software Preserve Support
7-26
Advertisement
Table of Contents
