Table of Contents
Advertisement
Link L0p Enable
Select Enable for Link L0p support. The options are Disable and Enable.
Link L1 Enable
Select Enable for Link L1 support. The options are Disable and Enable.
Early Snoop
Select Enable to support Early Snoop mode for the QPI link. The options are
Disable, Enable, and Auto.
Isoc
Select Enable to enable Isochronous support to meet QoS (Quality of Service)
requirements. This feature is especially important for virtualization technology.
The options are Disable and Enable.
Memory Configuration
Enforce POR
Select Enable to enforce POR restrictions on DDR4 frequency and voltage
programming. The options are Enabled and Disabled.
Memory Frequency
Use this item to set the maximum memory frequency for onboard memory
modules. The options are Auto, 1333, 1400, 1600, 1800, 1867, 2000, 2133,
2200, 2400, 2600, 2667, 2800, 2993, 3000, 3200, and Reserved.
Data Scrambling
Select Enabled to enable data scrambling to enhance system performance and
data integrity. The options are Auto, Disabled, and Enabled.
Enable ADR
Use this item to configure Automatic Diagnostic Repository (ADR) settings to
enhance memory performance. The options are Disabled and Enabled.
DRAM RAPL (Running Average Power Limit) Baseline
Use this item to set the run-time power-limit baseline for the DRAM modules.
The options are Disable, DRAM RAPL Mode 0, and DRAM RAPL Mode 1.
7-19
Chapter 7: AMI BIOS
Advertisement
Table of Contents
