Table of Contents
Advertisement
[Auto Live]
Select whether to use the auto live function.
When the auto live function is enabled and you capture a
still image, the captured image is displayed for the
duration specified with the [Duration] setting of [Auto
Live Settings].
When using the auto live function, you can select the
number of images to display during use ([Single] or
[Multi]).
When [Multi] is selected, three or four captured images
are displayed according to the display position setting.
The default setting is [Not Used].
[Advanced] appears when [Single] or [Multi] is selected.
For details on this setting, see "To configure auto live
settings" (page 60).
Tip
If [Auto Live] is set to [Use] while [I/O Timing] is set to
[Pass-Through], the auto live function will not function.
[Auto Live Still Image]
Displays the type of image that is displayed when a video
is paused while using the auto live function.
This is [Frame] on this unit.
To configure auto live settings
Configure display duration and position settings for the
captured images that are displayed when using the auto
live function.
1
Select [Advanced], and press the ENTER button.
The [Auto Live Settings] screen appears.
2
Configure each setting.
[Duration]
Select the duration for which captured still images are
displayed.
When [Single] is selected, select from 0.5 to 2
seconds for the duration. The default setting is [0.5
sec].
When [Multi] is selected, select from 1 to 5 seconds
for the duration. The default setting is [3 sec].
[Position]
Select from [Top], [Bottom], [Left], and [Right] for
the position in which captured still images are
displayed.
The default setting is [Left].
The four most recent still images are displayed when
[Top] or [Bottom] is selected, and the three most
recent still images are displayed when [Left] or
[Right] is selected.
3
When you finish configuration, select [Apply] and
press the ENTER button.
The [Auto Live] tab appears again.
[General 1] Tab
Configure initial system settings.
[Show Status]
Select the check box for the status you want to display.
You can select from [Rec Status], [Play Status], and [Idle
Status].
None of the check boxes are selected under default
settings.
Tip
If [Show Rec Status] or [Show Idle Status] is set to [Use]
while [I/O Timing] is set to [Pass-Through], the status
information will not be displayed. In addition, status
information will not be updated during the auto live
function.
[Image List Display]
Select the category of thumbnails to display for videos in
the [Image List] screen.
The default setting is [Title].
For details on [Advanced] settings, see "To configure
advanced image list settings" (page 60).
[Auto Eject BD/DVD]
Select whether to automatically eject BD/DVD discs
when they are full.
The default setting is [Not Used].
[Prohibit Remote Control]
Select whether to prohibit control of the unit via the
remote control buttons.
The default setting is [Not Used].
[Menu Display (SDI)]
Select whether to use the output of SDI output connector
D exclusively for displaying menus and other screens.
The default setting is [Not Used].
Tip
If [Menu Display (SDI)] is set to [Use], input images from
SDI output connectors A to D will not be displayed and
black screens will be output instead.
To configure advanced image list settings
Specify the selection state of recorded data when you
perform copy or print operations in the [Image List]
screen.
60
Advertisement
Table of Contents
