Table of Contents
Advertisement
WARNING
Using this unit for medical purposes
This equipment's connectors are not isolated.
Do not connect any device other than one which conforms
to IEC60601-1.
When an information technology device or AV device
that uses an alternating current is connected, current
leakage may result in an electric shock to the patient or
operator.
If use of such a device is unavoidable, isolate its power
supply by connecting an isolation transformer, or by
connecting an isolator between the connecting cables.
After implementing these measures, confirm that the
reduced risk now conforms to IEC60601-1.
Caution
Using this unit for medical purposes
Do not come into contact with the terminals of the rear
panel connectors and patients at the same time.
Doing so may result in a generation of voltage that can be
harmful to patients if the unit is malfunctioning.
Always disconnect the power cord before connecting and
disconnecting connectors.
a
SDI input connectors A to D (BNC type)
Inputs SDI signals (3G SDI).
Tips
• If SDI input images are not displayed, turn on the unit
first and make sure that startup is complete before
turning on the video input device.
• When receiving 4K signals, the four SDI inputs must be
synchronized.
• Embedded audio is not supported.
b
SDI output connectors A to D (BNC type)
Outputs SDI signals (3G SDI).
c
HDMI output connector (Type A)
Outputs HDMI signals.
Note
We recommend using a Sony HDMI cable (not
supplied).
d
Equipotential grounding terminal
Use this for equipotential grounding connections.
e
AC IN connector
Connect a power cord (not supplied) here.
f Main power switch
Set this to the ? (on) position to turn on the power. To
turn off the power, set the switch to the a (off)
position.
During regular use of the unit, leave the main power
switch in the ? (on) position, and use the qj 1 (on/
standby) switch on the front panel of the unit to
switch between operational mode and standby mode.
Note
When you press the qj 1 (on/standby) switch on the
front panel of the unit while the unit is in operational
mode, data is saved before the unit enters standby
mode. Always make sure that the unit is in standby
mode before setting the main power switch to the a
(off) position to turn off the power.
g
REMOTE contact switch connectors 1 to 4
(stereo mini jack)
Use these to control the unit via contact switches.
For details on contact switches, see "[Contact
Switch] Tab" (page 65).
h
USB port 7 (Type B / USB 2.0)
Use this to perform system controls from an external
device.
For details on system controls, see "[Control] Tab"
(page 64).
i
Network connector (RJ-45)
Connect a 1000 Base-T or 100 Base-TX network
cable here.
CAUTION
For safety, do not connect the connector for
peripheral device wiring that might have excessive
voltage to this port. Follow the instructions for this
port.
j
USB ports 3 to 6 (Type A / USB 2.0)
Connect USB devices here.
Tip
Supported USB devices
• Use Sony USB media.
• The connectors do not support all USB devices.
• USB hubs and devices with built-in hubs are not
supported.
21
Advertisement
Table of Contents
