Touch Control Yl146 (Basic) - Siemens EH70650 Repair Instructions

4.9

Touch Control YL146 (BASIC)

In induction cooktops, only the sensor and displays board of the TC is
used. The power supply is obtained from the induction modules.
The TC board communicates with the induction electronics boards by
serial communications based on LIN protocol (Local Interconnect
Network). The connection is made by a 4-wire cable.
There is another connection for the technical service connector.
Cooktops with touch control have the control zone marked on the
glass surface. The capacitive sensors are located underneath these
indicators.
Sensors, from left to right, in the YL 146-34 model (4i BO/SI):
►
Main switch (on, off, lock).
►
More and less, zone 1
►
More and less, zone 2
►
More and less, zone 3
►
More and less, zone 4
206_58300000105199_ara_en_h – 15.03.a
Sensors, from left to right, in the YL 146-31 (4i, 2i Ba) and the YL
146-30 (OLA Ba) models:
►
More and less, zone 1
►
More and less, zone 2
►
Main switch (on, off, lock).
►
More and less, zone 3
►
More and less, zone 4
Sensors, from left to right, in the YL 146-33 (2i BO, SI) model:
►
Main switch (on, off, lock).
►
More and less, zone 1
►
More and less, zone 2
►
Dual burner expansion
►
More and less, zone 3
►
More and less, zone 4
Sensors, from left to right, in the YL 146-32 (3i Ba) model:
►
Dual burner expansion
►
More and less, zone 1/2
►
Main switch (on, off, lock).
►
More and less, zone 3
►
More and less, zone 4
Seite 22 von 66