Maximum Number Of Connectable Modules/Maximum Configuration - Siemens PM-E F pm DC24V PROFIsafe Installation And Operating Manual

Configuring

2.3 Maximum Number of Connectable Modules/Maximum Configuration

Power Modules For a
Description,
See ...
PM-E
PM-E DC24..48V
DC24..48V
(6ES7138-
4CA50-0AB0)
Power Module
manual
PM-E
PM-E DC24..48V/
DC24..48V/AC
AC24..230V
24..230V (bis
6ES7138-
4CB11-0AB0)
Power Module
manual
See also
Properties of the PM-E F pm DC24V PROFIsafe Power Module (Page 62)
Properties of the PM-E F pp DC24V PROFIsafe Power Module (Page 83)
Properties of the PM-D F DC24V PROFIsafe Power Module (Page 96)
2.3 Maximum Number of Connectable Modules/Maximum Configuration
Maximum Number of Modules
The modules include the interface module, the power and electronic modules, and the motor
starters.
The overall width of an ET 200S is limited to 2 m.
The following restriction applies for IMs as of 6ES7151-1BA01-0AB only when operated in
DPV0 mode:
● The maximum number of modules in an ET 200S also depends on the parameter length
For further additional information refer to the
Instructions.
Table 2- 4
Fail-Safe Module
PM-E F pm DC24V PROFIsafe
PM-E F pp DC24V PROFIsafe
PM-D F DC24V PROFIsafe
4/8 F-DI DC24V PROFIsafe
4 F-DI/3 F-DO DC24V PROFIsafe
4 F-DO DC24V/2A PROFIsafe
24
Electronic Module/Motor Starter
Can be used with all standard and fail-
safe electronic modules
of the modules. Each ET 200S supports a total of 244 bytes.
Parameter Length of F-Modules in Bytes
Use and achievable SIL/Category/PL
Power supply to F-DI, F-DO
and F-RO modules
ET 200S Distributed I/O System
ET 200S Distributed I/O System - Fail-Safe Modules
Installation and Operating Manual, 08/2008, A5E00103686-07
SIL3/Cat.
4/PLe
Operating
Parameter Length
22 bytes
20 bytes
20 bytes
32 bytes
32 bytes
22 bytes