Using The Battery; Battery Features - VeriFone C680 3G-BT-WiFi Installation Manual

The C680 unit comes with a universal input power pack capable of operating from
voltages of 100 V to 240 V AC.
NOTE
To protect against possible damage caused by lightning strikes and electrical
surges, consider installing a power surge protector.
Once it loads the application, the terminal starts the initial Verifone copyright
screen and displays a unique copyright screen. If there is no available application
in the terminal,
copyright screen.
Using the
The C680 terminal uses a single cell Li-ion battery (see
Battery Documentation
both overcharging and undercharging (a fault condition in which the battery level
goes well below the minimum acceptable charge and the battery becomes
unusable).
NOTE
The C680 terminal will only operate when the battery is installed.

Battery Features

The following are features of the battery:
•
•
•
NOTE
•
•
•
DOWNLOAD NEEDED
for ordering information). The internal logic of the battery prevents
Single cell Li-ion 2450 mAH battery pack.
A safety circuit that:
•
Prevents cell damage from overcharge, over-discharge, or overheating.
•
Activates when the battery is left in an unused terminal for extended
periods.
C680 battery pack (PN BPK260-001-01-A) not customer changeable and
therefore should not be disconnected and removed.
Li-ion batteries are not affected by shallow charging. Furthermore, when the
terminal has no external power source or battery, the coin cell battery
provides power to the security circuit.
Disconnecting and removing the battery, as well as unplugging the terminal
power pack, reduce the life of the coin cell battery, which does not recharge
and must be replaced if drained.
Conserve battery power by turning the C680 terminal off when not in use.
Keep the Li-ion battery inserted in the terminal and power up the terminal
periodically to check the battery charge. Do not let the battery charge fall
below 10% for extended periods of time as this may permanently diminish the
battery capacity. Recharge the battery by attaching the micro-USB end of the
power pack to the terminal and plugging the other end of the power pack into
a wall outlet.
appears on screen after the initial Verifone
Accessories and
S
ETUP

Using the Battery

C680 I G
NSTALLATION UIDE
21