D-Link DIR-608 User Manual page 43

Section 3 - Configuration
LAN IPv6 Address Settings
Enable DHCP-PD: Check this box to enable DHCP-PD.
LAN IPv6 Address: If you disabled DHCP-PD, enter the LAN (local) IPv6 address for the
router.
LAN IPv6 Link- Displays the router's LAN link-local address.
Local Address:
Address Autoconfiguration Settings
Enable
Enable or disable the Automatic IPv6 Address Assignment feature.
Autoconfiguation:
LAN IPv6 Address: Select SLAAC+Stateless DHCP or Stateful DHCPv6.
If you choose SLAAC+Stateless DHCP, please configure the following field:
Router
Enter the IPv6 address lifetime (in minutes).
Advertisement
Lifetime:
If you choose Stateful DHCPv6, please configure the following field:
IPv6 Address
Enter the starting IPv6 address for the DHCP server's IPv6 assignment.
Range(Start):
IPv6 Address Enter the ending IPv6 address for the DHCP server's IPv6 assignment.
Range(End):
Router Enter the IPv6 address lifetime (in seconds).
Advertisement
Lifetime:
D-Link DIR-608 User Manual
PPPoE (continued)
LAN IPv6 Address Settings
Use this section to configure the internal network settings of
your router. If you change the LAN IPv6 Address here, you
may need to adjust your PC's network settings to access the
network again.
☑
Enable DHCP-PD:
LAN IPv6 Address:
LAN IPv6 Link-Local
Address: xx00:yy11:zz22:123/64
Address Autoconfiguration Settings
Use this section to setup IPv6 Autoconfiguration to assign IP
addresses to the computers on your network.
☑
Enable Autoconfiguration:
LAN IPv6 Address: SLAAC+Stateless DHCP
Router Advertisement
30
Lifetime:
Address Autoconfiguration Settings
Use this section to setup IPv6 Autoconfiguration to assign IP
addresses to the computers on your network.
☑
Enable Autoconfiguration:
LAN IPv6 Address:
Stateful(DHCPv6)
IPv6 Address Range(Start): xxxx
IPv6 Address Range(End): xxxx
Router Advertisement
Lifetime:
/64
▼
(minutes)
▼
::00 3
::00 16
(second)
39