Advertisement
Rea®Dahlia® electrical
3.3 Mounting the control box
Dahlia 30
F
1. Mount the upper part of the control box attachment A
in the attachment B on the chassis.
2. Mount the lower part of the control box attachment C
in the attachment D on the chassis.
3. Attach the control box attachment C with the pin E
and the locking washer F.
Nippers
Dahlia 45
1.
B
Loosen and remove the screws A from the attachment
plates B.
5 mm Allen key
2.
A
C
Mount the control box attachment C on the attachment
plates B.
3. Re-mount the screws A in order to fixate the control
box attachment.
4. Tighten the screws with 24 Nm.
5 mm Allen key
4
B
D
E
A
C
B
A
B
A
3.4 Cable lock — actuator
Cable lock removal
1. Loosen the cable lock A.
Use a screwdriver to loosen the cable lock.
2. Remove the cable lock from the actuator.
CAUTION!
Damage to the product
– When a cable lock is removed, it must be
replaced by a new one.
Mount the cable lock
1. Place the cable in the holder C on the seat tilt actuator.
The cable must be fully pressed into the holder
before adding the cable lock B.
2. Attach the cable lock B by pushing it into place on the
seat tilt actuator.
CAUTION!
Risk of damage to the product
– The cable lock must be mounted when washing
the wheelchair.
A
1587500-A
Advertisement
