Choke Rod - Stihl MS 311 Manual

2
: Engage tabs of handle
molding (1) in the
openings (arrow).
– Push down the handle
molding (1) until it snaps into
position.
– Check operation.
– Reassemble all other parts in the
reverse sequence.

10.2.1 Choke Rod

– Remove the air filter, b 12.1
2
: Carefully pry the choke rod (2)
out of its seat in the guide (arrow)
and move the switch shaft (1) in
the direction of cold start at the
same time.
MS 311, MS 391
1
: Move the switch shaft (1) in the
direction of the carburetor and
disconnect the choke rod (2).
– Take the choke rod (2) out of the
guide.
: Disconnect the choke rod (1)
from the choke shaft (arrow).
Installing
1
1
: Engage the choke rod (1) in the
bore (arrow) in the choke
shaft (2).
2
1
1
2
1
: Position the choke rod (1) in the
guide (arrow).
– Rotate the switch shaft (2) and
push the choke rod (1) fully into
the guide.
– Check operation – rotate the
switch shaft. If necessary, push
home the choke rod until it is
properly seated.
2
63