Whirlpool MW8650XS Use And Care Manual page 12

Q
5. Touch a Number pad for the
Cook Power you want.
The Display WIII show what you
touched This example shows you
touched Number Pad 5 for 50°0 of
full Dower
6. Touch START.
d
IXUflk
ClLLln
The AUTO SET Indicator Light will stay
on while the oven is cooking in the
pre-programmed cycle. If you
selected a Cook Power other than
HIGH, the COOK POWER Indicator
Light will also come on. This shows
you the oven is cooking at a se-
lected Cook Power.
The Display counts down the ttme
to show how much cooklng time
is left
When Auto Set ends,"End" will show
on the Display and 4 beeps will
sound. [You can stop the beeping by
opening the door or by touching
CANCEL.) "End" will remain on the
Display and a reminder tone will
sound every 60 seconds until the door
is opened or CANCEL is touched.
The Display will then show the time of
day
You can set COOK to follow Auto Set TIME, if desired. Touch in instructions for "Cooking in
Your Microwave Oven:' page 8; or "Cooking at Lower Cook Powers:' page 9.
Changing the Pre-Programmed Setting
You can change the pre-programmed cooking time and Cook Power in Auto Set TIME to the
time and power you most often use. To change the Auto Set TIME setting, follow these steps.
1.
Place food in the oven and close the door.
2. Touch TIME twice.
3. Touch the Number Pads for the desired cooking time. If HIGH Cook Power is desired, skip to
Step 6.
4.
Touch COOK POWER.
5. Touch the Number Pad forthe desired Cook Power.
6.
Touch START. The oven will cook at the new desired cooking time and Cook Power you
selected. After the cooking is complete, the oven will remember that time and Cook Power
for future use. NOTE: If the electric power ever goes off, the oven will go back to the
pre-programmed 2 minutes, 30 seconds at HIGH Cook Power setting.
12