Chapter 15
15.4.1.12 FEED ADJ
15.4.1.12.1 Overview
Making Feeding System Related Adjustments
15.4.1.12.2 <REGIST>
Method of
adjustment
Range of
adjustment
15.4.1.12.3 <ADJ REFE>
Method of
adjustment
Range of
adjustment
15.4.1.12.4 <BLK SML2>
Method of
adjustment
Range of
adjustment
15-86
Use it to adjust the timing at which the registration roller clutch goes on.
An increase of '1' will move the image toward the leading edge of paper by 0.1 mm.
Enter the value indicated on the service lable if you have initialized the RAM on the
DC controller PCB or if you have replaced the DC controller PCB.
50 to 50 (unit: 0.1 mm)
[at time of shipment: factory adjustment value/after RAM initialization: 0]
Use it to adjust the horizontal adjustment for duplexing (for factory use).
an increase of '1' will move the image on the 2nd side to move toward the
rear by 0.1 mm.
100 to 100
at time of shipment: factory adjustment value
upon RAM initialization: 0
Use it to adjust the left/right margin on the 2nd side for small size.
an increase of '1' will make the left right margin on the 2nd side
longer by 0.1 mm.
50 to +50 (unit: 0.1 mm)
at time of shipment: factory adjustment value
upon RAM initialization: 15
at time of shipment: factory adjustment value
upon RAM initialization: 0
T-15-102
T-15-103
T-15-104
0002-8458
0005-6928
0005-6929
0005-6930